How to get rid of window

In the cold time, condensate appears on some windows. On old wooden windows, such a phenomenon is much less common than on new PVC windows. Sometimes the fogging of plastic windows, or others occurs after the insulation and sealing of the slots. Sometimes windows begin to fog without visible reasons.

Most often, such a phenomenon manifests itself in the kitchen with a bad hood. Couple, which appears when boiling during cooking, settles and condenses on the cold surface of the glass. The manifestation of condensate inside the glass package - indicates its depressurization and the only way out will be replaced.

Causes of condensate on window glass

1. Condensate - in fact, the transition of steam into a liquid state when the "dew point" is transition. The main reason for the appearance of moisture on windows windows is to reduce air on the street and increased humidity indoors.
2. A significant impact on the appearance of condensate has a ventilation state. With the onset of cold weather, many try to preserve heat as much as possible and neglected even the elementary air ventilation.
3. Often the appearance of tears on the glass contributes to excessive sealing. But it happens on the contrary, when warm and wet air penetrates between windows and faces cold glass.
4. In the apartment, quite a lot of sources for evaporation of moisture. People themselves, exhausted air, increase air humidity. There are also aquariums, flower pots, bathroom and kitchen.
5. Heavy and dense curtains may prevent ventilation and natural air circulation. Often, the replacement of heat sources affects the well-established microclimate.

Fogging glass in wooden frames

1. Old wooden windows rarely stove. This is due to traditional installation methods. In the opening windows, under the standard frame, the installation provided a stock pad, which leveled the moisture balance and provided the stock for condensate.
2. After replacing old wooden windows to new, the stock overlaps, and the windows begin to foggle. Heating radiators are specifically located under the window openings. The heat coming from them, not only the windshields are warm, but also contribute to the overall circulation of air in the apartment.
3. New large and wide window sills can prevent the flow of heat flux. The heat screens will help to overcome such a misfortune. They are easy to make even independently. The narrow plates covered with silver foil are attached at an angle of 30 ° or 60 ° relative to the heat source to the window block on the windowsill.
4. Incorrect operation and errors in preparation for the winter period can lead to condensate. During the preparation of windows to the winter period, pay attention to the state of the rubber seal. It should be elastic and evenly passed on the entire perimeter of the window frame.
5. Periodically, the rubber seal requires the treatment with an alcohol cleaner, make sure that the rubber does not drive and do not lead to depressurization. It is unacceptable in the grooves of dirt and dust. If the rubber sealer came into disrepair, it is easy to replace it alone.

Ways to combat plastic windows

1. Old and proven way to put a thick decorative candle on the windowsill. Such candles are designed for several hours of burning. The effect of burning candles will immediately appear, the flame of the candle contributes to the active air movement, although it allocates little heat.
2. At the same time, fix all the flowing cranes, cover the aquarium and make the prevention of exhaust systems. Remove the flower pots from the window sill. You can put the windowsill fan and send the air flow to the window, and wipe the glass moistened in the vinegar with a rag. Wipe no less than once a week.
3. There is also an old folk remedy for moving windows in the apartment. A solution is prepared, which includes one part of the medical glycerin on 20 pieces of pure alcohol. The composition adds several drops of aromatic essential oil. It is recommended to wipe such a mixture at least once every 15 days.
4. In the auto shops for sale various chemicals from moving windows. You can use them. Such means on the dry and clean surface of the glass are applied. The effect of the use of such means is short-granded, expensive and unsafe for health.
5. If the fogging of PVC windows occurs in the middle of the glass package, it means that depressurization occurred. It is impossible to fix the problem yourself. Closer to the summer, he will evaporate himself, but with the onset of cold weather appear again. The masters, of course, can try to restore sealing, but most likely you have to replace the glass. Bigkeflakes are best behaved. Now there are windows from PVC with two modes - summer and winter, you just need not to forget on time, translate regimes by seasons.
6. Often the reason for fogging plastic windows is errors when installing, mounting and designing. Incorrect slope or invisible skew can contribute to incorrect heat exchange and cause condensed moisture on the double-blade of the plastic window and inside it. Remember that regular air ventilation, at least two times a day, will help in fighting the fogging of window glass.